Rocktron Utopia G200 Bedienungsanleitung PDF herunterladen (Seite 38)

The SOURCE 2 parameter is used to select whether the Source 2 input will be

the VOICE 2 output from the previous effect in the signal chain or the direct

signal (DIR).

The DELAY HIGH FREQUENCY DAMPING parameter controls the amount of

high frequency content in the delayed and regenerated signals. Higher amounts

of damping will result in less high frequency information in the delayed signal.

The OUTPUT LEVEL 1 parameter determines the volume of Delay 1 relative to

Delay 2.

The PAN 1 parameter allows you to pan the Delay 1 signal to the left or right

channel.

The DELAY TIME 1 parameter determines the length of time (in milliseconds)

after the input signal that the Delay 1 signal will begin.

The REGENERATION 1 parameter determines the number of times the Delay 1

signal will repeat itself. This is achieved by feeding the delayed output back into

the input. Higher parameter settings will result in more repeats. The displayed

value represents the attenuation (in dB) that the regeneration signal is subjected

to at each repeat.

The OUTPUT LEVEL 2 parameter determines the volume of Delay 2 relative to

Delay 1.

The PAN 2 parameter allows you to pan the Delay 2 signal to the left or right

channel.

The DELAY TIME 2 parameter determines the length of time after the input

signal that the Delay 2 signal will begin. This length of time is measured in mil

liseconds.

The REGENERATION 2 parameter determines the number of times the Delay 2

signal will repeat itself. This is achieved by feeding the delayed output back into

the input. Higher parameter settings will result in more repeats.

SOURCE 2

DLY HF DAMP

OUT LEVEL 1

PAN 1

DLY TIME 1

REGEN 1

OUT LEVEL 2

PAN 2

DLY TIME 2

REGEN 2

* The Delay features a regeneration limiter, since setting both REGEN parameters to high levels would result

in louder and louder echoes until a severe overload occurs. The limiter senses when this condition would

occur and automatically turns down both REGEN levels to avoid such an instability. This is especially

important when REGEN levels are being adjusted in real-time.

The regeneration levels can be reset by recalling the preset or by accessing the REGEN 1 and REGEN 2

parameters and turning the ADJUST control.

6. DELAY Function Continued.....

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 79 80

Kommentare zu diesen Handbüchern

Keine Kommentare

Rocktron Utopia G200 Bedienungsanleitung Seite 38

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Audio Rocktron Utopia G200